Ashfield Light Installation, Done Properly

Lighting shapes a room more than almost anything else we install, so it's worth getting right. Our scope covers:

Where the room calls for it, we reach for Beacon Lighting and SAL fittings rather than a generic import that fades or yellows within a year or two.

We also handle the small extras that finish a lighting job properly: motion sensors on outdoor lights, smart-home compatible switching, and matching plate finishes across a whole room rather than a mismatched mix.

Ashfield's mix of Federation cottages and mid-century flats means lighting jobs here fall into two camps. Older houses often still carry a single central light per room, wired for a era when lamps did the rest of the work.

Retrofitting downlights or feature lighting into a ceiling like that takes care, particularly where the roof space is tight or the ceiling itself is original. We work with what's there rather than against it.

The newer low-rise blocks scattered through the suburb bring a different job: modern boards but dated fittings from whenever the building was last touched up, ready for an LED upgrade.

We're also called out to older interwar apartment buildings with decorative plaster ceilings still intact from when they were first fitted out. The rose is worth keeping; the wiring feeding it usually isn't.

Every lighting quote is fixed in writing before we start, so what you're told is what you pay. A few things shift the number:

Quotes cost nothing to get, and new customers take $50 off the invoice.

Lighting jobs move quickly once we're on site.

1. We confirm the fittings and layout you're after.
2. We send through a fixed price before any switch gets touched.
3. We run cable and fit the lights, keeping mess to a minimum.
4. We test everything and clean up before we leave.

A handful of downlights is usually done inside half a day. A complete room re-light with new switching stretches closer to a full one.

A lighting job is easy to rush, and easy to get wrong in ways that only show up months later as a flickering fitting or a hot switch. We take the time to get the wiring right, not just the fitting on show.

Beacon Lighting and SAL gear feature heavily in what we install, chosen because they hold their finish and their function years after a cheaper import has faded.

If we've already been out for your board or your points, the same faces turn up for the lighting too. Nobody has to explain the house twice to a stranger.